Siecle MAP System 314

The Siecle MAP System 314 is a piggyback fuel and airflow controller that alters the air flow trim at a turn of the knob. The value of a vehicles fuel, ignition timing in the ECU fuel MAP is determined by ignition. By changing these two numbers MAP Engine performance fuel economy can improve. A simple plug and play installation without the need to splice any wires, the Siecle MAP System 314 is the most value for money piggyback system for modern cars today. For fuel economy and performance gains with just a simple twist of the knob that streamlines and determines the air fuel ratio average across the whole RPM range and alters ignition timing to suit the air fuel ratio as well.

The Siecle MAP System 314 has a 10 settings range for varied engine performance gains and different driving conditions.

Dialing the knob clockwise dilutes the fuel and advances the ignition timing.

While it's active it has intermittent flashing of LED light. (Note: At idling it does not operate)

Improves acceleration feel and improves fuel economy. Torque and horsepower gains are also imminent.

Installation DCM connector is necessary without the need to splice any wires (sold separately). It is a cable connector for air flow meter (or pressure sensor) connected between the factory connector.

You don't need other piggyback, it can alter air fuel and ignition timing on stock ECU. If you already have a piggyback, it can be use as a sub-controller to the existing piggyback to finer adjust/tune when you want it to be slightly leaner or richer.

R-VIT i-Color

The R-VIT i-Color is a monitoring multi meter designed for 2003 or later Toyota CAN-bus or japanese vehicles equipped with OBDII diagnostic connector 96 or later.

The R-VIT i-Color uses the same 65,000 Color LCD screen and multi angle display. as the SBC and MMD i Color boost controllers.

The display can be set to three different angles depending on the installation.

Monitors a maximum of 29 items and able to display 6 monitored items simultaneously.

Monitored items are: Speed, RPM, Water Temp, Ignition Timing, Fuel Injection Time, Air Flow Voltage, Outside Temp, Intake Manifold Pressure, Boost, O2 Voltage, O2 Rear Voltage, AF 1, AF 2, Intake Air Mass , Battery Voltage, Throttle Output, AT Temp, Gear Position, 4WD Ratio, Fuel Pressure, Momentarily Fuel Consumption, Error Diagnosis Code, Lock Up ON · OFF.

External Voltage Input (Press, A/F Box) / External Temp Input, Fuel Pressure Control, Fuel Injection Control / Electric Fan Control, etc.

Depending on the vehicle, the monitored items may vary or may not be monitored.

The optional Pressure Sensor (or) the A/F Box must be separately purchased to display the external voltage input.

The optional Temp Sensor must be separately purchased to display the External Temp Input.Press Sensor Set (19211)

Temp Sensor Set (19210)

A/F Box (15063)

On active Control Function *CAN System Vehicles 2006+ Toyota/Lexus (except Hybrid)The Fuel Pressure, Fuel Injection and Electric Fan can be controller actively. There are some vehicles that this function cannot be used.

The fuel pressure can be controlled every 100 RPM and can be increased or decreased from -9.9 to 2.5%.

The fuel injection can be controlled every 500 RPM within the 3000 RPM range and can be increased of decreased up to ± 25%.

The electric fan can be controlled to go ON or OFF within 20 to 100 degrees of the water temp.

Data Record and Play /Graphical Display - a maximum of 10 minutes recording time. Graphically displays the AF 1/ AF 2 and the external voltage input based on RPM. (Useful for tuning)

Only the external voltage input can be displayed if the AF 1/ AF 2 cannot be monitored.

The Meet Up

i was washing my ride to get it ready for the Group meet up at Jerudong Park food stall with mr Sam.i was too excited that my exciting feeling only last for couple of minute,cause i left my camera with the battery is dead at mr sam ride, so mr sam decide to lent me his camera and he let me do the photoshoot. There were a couple of ride from Brunei ES Team , BST ,BSP and some other cool ride as well attending the meet up.

when they start to rev it up The Sound of Three R35 going passing thru the tunnel does seem pretty much Nasty cause my ride nearly had a massive heart attack

The Brunei ES Team

The Godzilla's

Brunei Compact Tuners Crews

At the End everyone was exhausted due to the very hot sunny day ,so we decided that we gonna end up everything at the Stadium But for us we stop by some food court had a bucket of ice heaven and earth green tea and ice milo.

Please Insert Token to play this Machine.

Borneo Tuner: Photoshoot In Brunei

It was Kinda cool meeting up with Borneo Tuner and have Breakfast with them. I Realise their ride wasn't an ordinary ride, it was a Subaru forester and its sounded really nasty.

One of Borneo Tuner Magazine

If you Want to purchase a copy of Borneo Tuner magazine
you can call them up at

+6738835843 or +6738970000

or go to their

Borneo Tuner Office Location :

Block A, Unit 6, 1st Floor,
Kg Batu Bersurat, Jln Gadong.

Plus You can Also Like their Fan Page at FaceBook

Borneo Tuner

Fun Journey: Miri Part 3

Next journey we went around piasau road in a heavy rain looking for something that might be interesting,we did manage to find some cool aftermarket parts and also did took a picture of their awesome ride as well.

Gotta Love this Ride! Is it a kenari or what? Anyway i like it!

after surveying at piasau road we went back to the workshop and see how its going with the car,there were some few interesting car during our time there.

Hifonic Shop

Before we went home we have to make a pit stop at this new
fueling station which have Mc donald on the side of it, yes again
at Mc donald ,we are totally addicted to burgers.
whoever thought of this making Mcdonald next to
the fueling station was totally a great idea.